DD fluidized bed reactor without pump

DD's Fluidized Bed Reactor is the ultimate economical solution for fluidizing a variety of media in marine and freshwater aquariums.

It is characterized by its compactness and efficiency and is suitable for hobbyists of all kinds.

Can be used for the following media:

– Rowaphos or phosphate remover
– Nutrifix organic pellets (up to 700 ml)
- Money
– Biological sand as a fluidized sand filter

Dimensions

– 128mm x 94mm x 440mm (including accessories and lid)
– Outer diameter of the reaction tube – 80 mm
– Height of the pipe between the upper/lower perforated plates – 340 mm
– Can be hung on glass up to 25mm
– Tube 17mmOD x 14mmID
– Can stand in smaller containers or hang from taller containers
- Plug & Play

Delivery

– FMR reactor
– 3 x Clear Plastic Tubes
- Check valve
– Tap for flow adjustment
– 2 types of media sponges (1 piece each)
– 8 x cable ties to secure the pipes

Flexibility

The reactor can be mounted in different positions depending on the system. It can stand in or next to the technical pool or be hung on it. Using the holder integrated into the lid, it can also be hung and attached directly to the pool. The inlet and outlet pipes can be placed in different positions to allow the piping to run in different directions.

Efficient swirling

The bottom of the housing is curved to distribute an even flow of water from the central downpipe over 360 degrees, eliminating blind spots.

Below this is a perforated diffusion plate that acts as a bottom support for the media when not turned on, creating an empty plenum area that allows for faster fluidization when turned back on and prevents compaction of the media at the bottom of the reactor.

A coarse sponge is intended for use with fine materials that can pass through the perforated plate, but this is not typically necessary for most media.